Made of CNC machined T-6061 Billet Aluminum.
After all the machining is done, the shift boot adapter is beautifully hard anodized, to ensure a long lasting finish, and to provide years of trouble free service and looks. VMS Racing shift boot adapters are manufactured of Aircraft Quality T-6061 Billet Aluminum, and then they are precision machined to exacting tolerances.
Shift boot adapter is made to Work on Manual transmission vehicles ONLY.
With this clip you can lower your shift knob as far down as you can, and still keep your boot in place! Most of the shift boot adapter that are out there will make your shift knob sit 1 to 2 inches HIGHER THAN STOCK! This will make you shifts slower and less accurate. This allows the use of a wider variety of shift knobs on your 2005-2014 Ford Mustang.Īnother major advantage is that you do not have to raise your shift knob with this boot retaining clip. From VMS Racing comes this billet aluminum shift boot retaining clip that allows you to hold the shift boot up independently on your shift knob. VMS Racing shift boot adapter clip WITH set screw in T-6061 billet aluminum that will fit most 2005-2014 Ford Mustang with manual transmissions including the 2005-2009 Shelby Mustang (WILL NOT FIT THE 2010-2014 SHELBY MUSTANG).ĭon't limit your selection to only shift knobs with built-in boot retaining clips. Made of 7075 T6 CNC machined billet aluminum. Direct replacement for the OEM rubber bushings. These billet bushing kits are manufactured of aircraft quality 7075 T6 CNC machined billet aluminum, and are anodized in a gunmetal color for a long lasting finish and durability. The VMS Racing Billet Bushing Kit is a great, low cost way to improve your stock shifter. This billet shifter bushing kit, replaces the factory OEM rubber bushings and creates a direct contact between the floor pan and the shifter assembly box, creating a very precise and solid feel shift. The VMS Racing billet aluminum 8 piece shifter bushings replaces the stock shifter box soft rubber bushings, for an improved shifter feel. These eliminate the sloppy, vague and mushy feeling of the stock shifter, as it is always moving around on the factory soft rubber bushings. THIS BUSHING KIT WILL FIT THE FOLLOWING VEHICLES:
Improve you shift precision and response with the new VMS Racing billet shifter bushing kit today! The VMS bushing kit features 2 locating bosses for proper alignment and easy installation. This kit will replace the OEM rubber bushings, which will eliminate shifter play for smoother, more precise shifts while still retaining the OEM shift linkage and shifter. Each bushing body is beautifully anodized for maximum durability. One interesting use for 7075 is in the manufacture of M16 rifles for the American military. 7075-T6 Aluminum has an ultimate tensile strength of 74,000–78,000 psi (510–572 MPa) and yield strength of at least 63,000–69,000 psi (434–503 MPa) which is comparable to steel, but at a fraction of the weight. These bushings are manufactured completely from AL7075-T6 billet aluminum.
New from VMS Racing!!! 2 piece billet shifter bushings for B and D series engines.